# Changing target faces

**URL:** <https://forum.ryngdyng.com/t/changing-target-faces/36>\
**Category:** Training\
**Created:** [March 26, 2021, 12:34pm UTC](https://forum.ryngdyng.com/t/changing-target-faces/36 "2021-03-26T12:34:36Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![Anonymous1](https://forum.ryngdyng.com/user_avatar/forum.ryngdyng.com/anonymous1/32/22_2.png) [@Anonymous1](https://forum.ryngdyng.com/u/Anonymous1)\
**Post date:** [March 26, 2021, 12:34pm UTC](https://forum.ryngdyng.com/t/changing-target-faces/36/1 "2021-03-26T12:34:37Z")

</div>

If we want to change a used up target face, do we always need to calibrate again?

---

<div class="post-metadata">

**Author:** ![Jochen](https://forum.ryngdyng.com/user_avatar/forum.ryngdyng.com/jochen/32/11_2.png) [@Jochen](https://forum.ryngdyng.com/u/Jochen)\
**Post date:** [March 26, 2021, 12:40pm UTC](https://forum.ryngdyng.com/t/changing-target-faces/36/2 "2021-03-26T12:40:03Z")

</div>

Changing target faces is quite simple:

1. stop arrow detection
2. remove old target face and put a new one
3. go to page `calibration -> target recognition` and press `target recognition`
4. start arrow detection and continue with your training

In case you are using the same type of target face and you manage to pin it at the same position as the previous one (with an accuracy of ±1 cm), then you could even skip step 3.